6 operation errors easily damage the mesh chain conveyor

Net chain conveyor is a belt conveyor, the use of wire preparation of the net belt as the carrier, on both sides of the chain with a pin connection in the middle, the sprocket drive chain so that the net belt along the chain transmission direction and movement; Can directly use of special rubber roller to directly drive the drive, the former is generally applicable to the material weight heavier and longer length delivery form, used in cool, dry, and other industries require delivery, so thin mesh belt density, which typically USES a relatively dense mesh belt, suitable for material conveying distance is shorter and smaller or special delivery of the object, For example, transport of materials with strong magnetism. The general length of heavy mesh belt conveyor is not more than 15 meters, the width is not more than 2 meters; The length of light stainless steel mesh belt conveyor is generally not more than 10 meters. Network chain conveyor and industrial production are inseparable, today risen for you to explain the reasons for easy damage to the conveyor in the process of using network chain conveyor.



1, network chain conveyor initial feeding, should gradually increase the feeding speed until reaching the rated conveying capacity, feeding should be uniform, otherwise easy to cause the accumulation of conveying material plug, driving device overload, so that the whole machine premature damage.



2, the conveying material shall not be mixed with hard large material to avoid screw stuck and caused by the damage of the screw machine.



3. Abnormal phenomena occurring in the operation of the network chain conveyor should be checked and eliminated, and shall not be forced to operate.



4. In use, often inspect the working state of each part of the screw machine, pay attention to whether the fasteners are loose. If the parts are loose, the screws should be tightened immediately to retighten them.



5, the network chain conveyor should be no load starting, that is, in the shell no material starting, starting to screw machine feeding.



6, the movement of the network chain conveyor should often add lubricating oil.